By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
This is a customizable handle for a wheelbarrow. It was designed for rod with a diameter of 30 mm. It may as well work as a handle for other uses. If needed, there is attached an .f3d file, where you can customize it to the desired rod diameter.
Modification instructions
Open .f3d file in Fusion 360.
Open Change Parameters.
Edit rodDiamater parameter under UserParameters.
Recommended print settings
layer height: 0.2 mm
infill: 10% gyroid
perimeters: 4
solid layers: 6
avoid crossing perimeters: yes
supports: no
Avoid crossing perimeters (combing) should be enabled to prevent unwanted stringing inside. Print it as it is - on the closed side.
For this kind of application, printing with ASA or similar filament is recommended.