J

Awarded to:jtoddmess

First Make published

Feb 17, 2026 · 4:56 AM

J

jtoddmess

1 follower0 downloads

Achievements

Trailblazer

25 Models downloaded

Novice Maker

First Make published

Sort by:

Snowdragon 2025

Snowdragon 2025 - So the Bambu slicer told me I needed supports which I obviously did not. I wish I’d read the instructions with this design and realized that before, but it didn’t add much waste—just a few grams.

I hadn’t done many multi-color prints yet as I’m fairly new to 3D printing, but the 90 grams of printer poop was nearly half the 185grams I had in my previous 500+ hours of printing. I get why that is, but I think I’ll probably not do a lot of prints like this in the future due to the waste. Again, I understand that’s the nature of designs like this, so not a complaint. Just an observation.

And the waste would have been the same if I printed 1 or 4, so I printed 4 which was the most I could fit on my plate. I used a silk silver from Epelay for the grey and a matte rainbow for the main body color from Eryone. The black was from Inland and the white from SUNLU.

Overall a cute result! - 3d model

XL Leprechaun (for larger build plates above 300x300x300)

XL Leprechaun (for larger build plates above 300x300x300) - I’m new to 3D printing and this was my first big project. It was about 84 hours of printing total about about 2.5kg of filament total. I couldn’t be more pleased with the results. The default supports were a bit odd in places and some of them in the small connector cavities will need some work with a power tool to get cleaned out well enough to put in the connector pegs, but overall this thing was a dream. It’s much more substantial and whimsical than I had expected. I used SUNLU beige for the skin tone and it’s perfect. Thanks for the great design! - 3d model