Kingroon KP5L runnout sensor connector

This connector is used to attach the PTFE reverse Bowden connection from the filament runout sensor. 

Printed in PLA
The sensor side of the connector is a bit tight, so I ran a 5/16 drill bit in in to clearance. After that it fit fine. I attached it will a small amount of hot glue. 
The PTFE tube press fit just fine. 

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

jplemoine

Achievements

Seedling

Kingroon KP5L runnout sensor connector