Turn Signal cam for early A body molar (1960's)

turn signal abody 64.3mf

1964 Dodge Dart GT hood emblem badge insert

GT Dart Hood Emblem Badge.3mf

Dodge 1964 rear fratzog trunk badge GT

GT Trunk Badge.3mf

Bushnell Optics Riser Shim

optics_riser_bushnell.3mf

Mopar Gauge Screw Cover

Dart Gauge Screw Cover v4.3mf

Kodak Step camera case

kodak step camera case v2.3mf

Tumbler Pocket Knife Sharpening Block

TumblerPocketKnifeBlock.3mf

Vinyl Wall Displayer v6.3mf

1964 Dodge Reverse & Taillight Gasket

Reverse_Light_Gasket.3mf

DODGE PLYMOUTH A BODY TRIM CLIP

This is a trim clip for the silver/chrome trim that runs the length of the car. 

Originally printed for my 1964 dodge dart gt. The clips slide into the rails and press into the holes on the body. They are robust and even reusable, a few times anyway. I usually print 50 at a time out of PETG and and 0.2 mm nozzle (Super quality on Cura) - this gets me a sturdy clip that still slides in the rails. 

DODGE PLYMOUTH CHRYSLER - A BODY GLOVE BOX

This was originally designed for my 1964 Dodge Dart GT - so the glovebox may vary a bit. 

I would print in PETG with no supports (overhangs end up fine) and clip off the tiny support rods at the top. 

Print 2 of the flat plates, then glue it all together like legos. I did this because my printer is too small for the whole thing. 

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

joshuamwicker

Achievements

Explorer

Seedling