Awarded to:joshmikeking

First Make published

Jun 21, 2024 · 8:19 PM

joshmikeking

0 followers0 downloads

Achievements

Novice Maker

First Make published

Voyager

50 Models downloaded

Sort by:

Bambookends

Bambookends - Had to set my support angle to 75 to get Cura to generate supports only on the bottom of the pot. That's a pretty big stretch to go without supports but apparently everyone else does it no problem 🤷 Also I can't get over the irony of having to destroy 7 perfectly good highlighters to make 5 novelty ones, lol. Neat though innit!? - 3d model

Tickler SA

Tickler SA - Turned out pretty ok! I had to print most of the smaller parts on a raft to get them to stick, resulting in some ugly faces, but you can't really tell unless you're looking super close. The clip release button/lock broke after 1 use and it's holding better with super glue lol. The housing rear nut sheared itself apart while screwing it in so I'm reprinting it with 50%infill. The housing I think got warped because I took the left one off the bed while it was still hot. So I might do another make with a new color scheme. Maybe red highlights so I don't get shot if I ever take it out in public 😭

Haven't tried loading it yet but it's on my to do list. The trigger and clip move smoothly enough on their rubber bands. I think it will work well enough. Although the trigger had some trouble seizing up at first until I grinded out some imperceptible support gunk. Overall a good model. Thanks! - 3d model

Tickler SA

Tickler SA - Did a filament swap before layer 75 and after 80. Turned out nice! Remember gcode starts at 0 not 1 so I put the M600 command before 74 and after 79 respectively. Can't wait to finish this and get it functional! - 3d model

Venus Flytrap Snack Clips

Venus Flytrap Snack Clips - Finally done! Took me WEEKS to get my printer refurbished and calibrated but I really wanted to make some of these plant prints. - 3d model