In honor of PexPeppers being my hot sauce of choice, I present my floppy jalapeno!

Two types of prints are available. There are files that allow you to print the jalapeno and stem separately and assemble them and there are files where it has the jalapeno and stem combined.

Print Instructions:

• Layer Height: 0.16mm
• First layer Height: 0.16mm
• Supports: Nope!
• Wall loops: 3

Make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also works, but not guaranteed to work.

Thank you for your time and consideration on this matter.

Feel free to join my discord for additional support, questions, or suggestions!