This model was made in collaboration with Gazzaladra.
An Apple Magsafe charger tray with a little extra space for small items.
Requires:
1x Apple Magsafe Charger (last gen)
Instructions Size: 216 x 216 x 20 mm Print the part Insert the cable from above Press the charger into the tray Enjoy!
Print settings All Parts Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0.4 mm Line width: 0.4 mm Layer height 0.2 mm Outer walls: 3 Infill: 15%
Speed: To avoid a bad surface in the upper layers, make sure to pay attention to your speed settings. Build plate adhesion type: brim or raft Support: Not necessary but advised for a better fit of the charger. Tree support with a 30 degree “threshold angle”. (in Cura the number is calculated 90-30 – so put 60 in “Support overhang angle”)