Little bunny cottontail, hopping down the printer trail!! Perfect for your Easter baskets and shows!

These fidgets make a satisfying click when fitted with a key switch.

There is a single color STL model, and a multicolor 3MF file. Also one with and without keychain holes. Ball chains work great for all my keychain models.

Most key switches fit nice and tight. I recommended Kailh box white 3-pin key switches. They are good quality and very clicky! They are also easily available on Amazon or AliExpress.

NOTE-- The tail only clicks cleanly when installed in the proper direction. Refer to the photo of the model for reference.

3D printing settings

0.16-0.2 layer height

2 walls

detect thin walls ON

arachne walls

concentric top layers

top shell layers 4

8% gyroid infill

NO supports

only one layer on top surfaces OFF*

*This is a setting under Quality on Bambu Studio. You should leave it permanently OFF (NOT APPLIED) in order to get better top surfaces on your prints.