Remember the commercial with the button that said "That was easy!!" Well, I had a few requests for it, so I thought I would make on for you!

There is a single color STL model, and a multicolor 3MF file. No AMS is needed, as you can do a color change at layer.

Most key switches fit nice and tight. If your key switch has an outline around the center cross and does not fit in the cap, the outline can be trimmed off for a good fit.

3D printing settings

0.16 layer height

2 walls

detect thin walls ON

arachne walls

monotonic top layers

top shell layers 4

8% gyroid infill

NO supports

only one layer on top surfaces OFF*

*This is a setting under Quality on Bambu Studio. You should leave it permanently OFF (NOT APPLIED) in order to get better top surfaces on your prints.