DampRid has some very large desiccant "flakes" that are very easy to get here in Australia at BigW or Kmart.

All other models here have got holes all the way down, which wont work for how these flakes work. They slowly disintegrate which then leaves some moisture at the bottom of the container. 

This model has got a lid that cleanly snaps on, a mid that can hold a good amount of the “flakes” and a base that collects any leftovers with the help of some small holes in the bottom of the “mid”

Please feel free to let me know if any changes are needed, but from my testing it works well :) 

DampRid Desiccator

Body.stl

A simple replacement handle for most cheap spray bottles.

Split in half in your slicer, or simply print the "Pre Split" Model if you're using the exact same size.

You should sand the contacting edges to help the glue stick better.

You will also need to drill out the holes in the handles to 3.2mm and use a hammer to get the pin through the bottle and the handle as its designed to be a very tight fit.

EDIT 04/02/2023 Changed size of pin to fit a bit better

Spray Bottle Handle

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5021718.

I have created a little phone holder in about 10 minutes. 
Haven't printed yet but will when I have time!

Feedback is greatly appreciated!

Small Phone Holder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5813584.

A small clip to stop the water container from air locking on a Samsung Fridge.

Anti Air Lock for Samsung Fridge

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5813587.

This is a stand for the standard 840ml Soda Stream bottles.

This is MK1 with MK2 coming shortly which is much smaller but supports the bottle from the inside which could be used for the smaller bottles as well!

Soda Stream Bottle Drainer

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5815116.

This is a smaller version of https://www.thingiverse.com/thing:5813587.

This design uses the middle of the bottle instead of supporting the outside making it print much faster and using less material to achieve the same end result. 

Soda Stream Bottle Drainer MK2

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5813590.

Just a headphone holder that I designed because I didn't like the ones I saw on here.

It originally was going to fit around my PC case but turned out to be SLIGHTLY too wide for my print bed :(

Headphone Holder

Hi, Im Jake, I have both commercial and personal experience in modelling, manly in Inventor.

Im wanting to create some cool parts for everyone... once I can think of what to make!

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

jakewelch23

Achievements

Sequoia