This is a mounting bracket to clip a PC Micorophone onto a Mic hlder made by Newer.

PC Microphone Holder - Clip on to Newer Mic Holder

I use this to prop my PC keyboards up a little higher then what the factory riser clips will prop a keyboard up.

Keyboard Support Wedge

A batman-ish Headphone holder, that also has a place to store the usb BlueTooth adapter

HeadphoneHolderE-PartBody.stl

If you do make this please trim back the flared out portion or it will bump into the vertical supports when trying to home  or if you are printing an object close to the right hand side.  I haven not updated the model. I trimmed it back with a dremel. I had an issue with the print head assembly cable header slipping out of it's mating connector on the print head assembly. I probably just needed to tighten the tie strap but knowing that the current in a couple of those cables has to power the heating element I didn't want that cable too tight. So I made this clamp to hold the connector in place.

PrintHeadAssemblyCableClip_Final-Part.stl

LED bracket that will hold 100MM (6 leds) of the LED stripe lighting. This bracket mounts to the right hand screws for the X axis tension bracket. and shines the lights from the right side of the bed to the left side. Which is usually the angle I use to watch the print process. It might not be a bad idea to adjust it slightly so it does not block a portion of the control panel LCD.

LEDStrip_100mm_SingleRow_Final-Part.stl

This pen holder is designed to be screwed/bolted to the side of a cabinet. In my case I bolted it to the side of the upper portion of my cabinet. So it doesn't take up any desk space.

Cabinet Side Mounted Pen Holder

CabinetSideMountedPenHolder_F1-MainShell.stl

Just a cable guide that beginners can make when first starting out using the GeeeTech A10M, Should work on the GeeeTech A10 as well.

YAxisNemaShield_5.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like