Magnetic Door Holder.stl

I designed this for a netting door.
I'm using neodymium magnets (10mmx20mm), It's got slots for 2 magnets but I ended up only using 1, they're quite strong.

Headphone Stand.stl

I designed it to glue to the end of my table.
If I was to re-design it, I'd add a bump to the end so that the headphones couldn't slide, and since it's glued, the long vertical part is redundant.

light holder.stl

I designed this to direct light onto my working space, it's a shelf, so it's got a ceiling that's about 50cm high.
It's glued with epoxy and is starting to show signs of warping, but I doubt that it's going to get unstuck.
I'm using a fluorescent bulb so that explains the warping issues, as it gets to about 50°C.

lithophane photo holder V1

main body II.stl

Kitchen Light Holder.stl

It's designed to hold the cord at the right position on top of the table (the place the wire exits the ceiling Is off center with the table).

kitchen shelf (small)

main body I.stl

Towel Peg.stl

I designed this quickly, its not great.

To improve the design you'd have to make the peg extend outwards +5 - 10mm.

It's a good idea the PLA is surprisingly strong.

The holes are 2.8mm in diameter.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

healdlorenzo

Achievements

Seedling