This part allows for temporary repair of a transmission kickdown cable that has pulled out of the metal ferrule and is making the throttle pedal sticky.  Instructions: Print two up on end, place on ether side of the joint from the cable and the ferrule, slip two heavy duty cable ties on, and crank down the cable ties.  Make sure to print out of something that can take the heat under the hood, like ABS or CF-PET.  Warning: The goal here is to make the car safer by temporarily keeping the pedal from sticking.  This is not a permanent fix.  Get a new cable ordered and fix the problem.  You are messing with the thing that makes the car accelerate, don't mess if you don't feel comfortable with it.  I accept to liability for you making a mod to your car.

Volvo 240 kick-down cable splint

kickdowncablesuport.stp

These rings slips over the front wheels of the walker allowing the front to slide, making it handle like a shopping cart.  It takes a fair bit of force to get them on, so they shouldn't slip off.  Upscale a few percent and reprint if they don't go on at all.  Reminder: Print out of a material and color that wont mark the floor(pictured is clear PETG).  Warning: These will make the cart less stable and unsuitable as a walker.  Do not use these if your child uses the cart for stability!  Only use these if your child wants to use it as a cart for transporting things.  I accept no responsibility for you modifying your property.

IKEA UPPSTÅ Toddler walker caster rings

sriftrings.stp

This bracket replaces the rubber mat in the cubby at the bottom of the center console.  Ten 1/4-20 UNC nuts provide mounting points for accessories like phone holders or radios.

Instructions:
Do Not Print In PLA
PLA becomes too soft in high temperatures of a car sitting in the sun.  PETG or ABS/ASA is recommended.  The geometry of this part has been designed for minimal warp.
Print at .2mm, 3-4 walls/loops, 20-30% infill.
Break away the support/cooling bar by rocking it with plyers.  Break away the small supports under the hooks.  Use a bolt and 2-3 washers place through the holes to pull the 1/4-20 nuts down into the hex holes(this also ream the holes to clear the bolts).  Remove the panel from the car by prying it upward, there is one clip in each corner.  Open the clips holding rubber mat.  With the mat removed insert the hooks into the slots and place the clips back up though their holes and clip them onto the printed part.  Re insert the panel into the car.

Notes:
1.  Using too long of a bolt will press against the OEM panel and lift the printed part.
2.  RAM and GoPro have mounts that attach via a 1/2-20 stud.
3.  A mount for a backseat baby monitor has been upload as a reference of how to mount to the new plate.
4.  The original CREO file has been included.

2018-2023 Crosstrek cubby Bracket

xtrekCubbyMount.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

halodine

Achievements

Seedling

Explorer

Volvo 240 kick-down cable splint

IKEA UPPSTÅ Toddler walker caster rings

2018-2023 Crosstrek cubby Bracket