goBILDA Custom Servo Mount for Cascading Lift kit

FTC 
-------
This custom servo mount allows you to mount your servo on the final stage of your cascading lift kit.

This uses goBILDA 24mm standoffs to mount the servo to the 3D printed mount, with space for the screw end of a goBILDA m4 screw on the bottom. 

The included clips and holes on the mount walls allow extra grip on the servo, making sure it doesn't go anywhere while you're driving about the field in case one of your screws shimmy out over time.

I recommend printing this no lower than 50% infill, as the walls are somewhat fragile, as this was intended to be printed with PLA.

Soap Dish

This soap dish prints with supports. 

This fits pretty much any bar soap out there, I designed mine to fit dr squatch-sized soaps.

The walls are good at keeping the soap from slipping out at any point and the drain holes let the water from the soap funnel out. Soap usually dries 5-10 mins after you put it on the dish.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

farleyman14

Achievements

Seedling

goBILDA Custom Servo Mount for Cascading Lift kit

Soap Dish