Slotcar track holder clip

### What's this

This thing is a clip to help keep two slotcar track pieces joined together.
It was designed for a very old (40+ years old) slotcar racing track I own.

The racing track originally came with a lot of these clips but unfortunately many were lost over the years.

If you have a similar slotcar racing track from the early 1980s you'll probably need to make a bunch of these clips like I did.


### Printing tips
The pictures show a few clips I printed, all at the same time, at a resolution of 0.2mm.

- You can try to use lower resolutions like 0.28mm or 0.32mm  but keep in mind they will look uglier and will become more fragile and prone to break.
- Print them **vertically**
- Add **Brim** to help them stick to the print bed
- Use **Tree Supports** , not normal supports

And finally, print a few/bunch of them at the same time! Just place them 1cm or so apart from the each other.






Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

enide

Achievements

Seedling

Slotcar track holder clip