DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
emsawyers’s profile picture

emsawyers

0 followers0 downloads

Achievements

50 Models downloaded badge
Voyager
50 Models downloaded
First Make published badge
Novice Maker
First Make published
All
Sort by:

Sushi Clickers

Sushi Clickers - I have mixed feeling about this one. Theu came out okay, but the model itself has a lot of unsupported overhangs where bridging doesn't work out. One of the caps (Avocado Masago) also has a hole in it that does straight though the model (it's next to the dark green avocado & hard to see in my image.) Probably most won't notice, but it bothers me.) the salmon avocado ends up having a bleeding issue from the green below the salmon piece. The orange is only 1-2 layers above the green and It's not a flushing issue either. I reprinted them nearly doubling the flushing volume just to make sure. I ended up going with a slight lighter green (PolyTerra Satin Green) and that helped a little bit. The Base (Eryone Black Forest Green Matte) where the cap goes in one side and the switch goes in the other. The wall there is super thin and very very easy to break when pushing it in. I recommend putting the switch in first & then pushing the other side's cap on while pressing on the switch to make sure the post of the cap doesn't break through. - 3d model

Easter Egg Clickers

Easter Egg Clickers - Prints real well. About 4 hours for the case using Polymaker Peanut. I glued switches in, in order to make sure everything stayed in place. I also added a 4mm hole on one side so I could put a cable chain on it and carry it around. Lastly, I used a hair tie to hold it closed. - 3d model

Bendy Bonsai

Bendy Bonsai - Printed great. The hinges are a little fragile, especially if you print in a matte filament; otherwise, these were fun and got a lot of attention at a recent market. - 3d model

Spinny Succulents

Spinny Succulents - Bearings fit loose on test prints. Resized to 99% and they snapped in snuggly. Printed only the Pots with the seam to the back. The succulents were set to Aligned. All printed well. If you print the succulents on a SuperTack plate, the supports will be difficult to remove 🫢. Had to heat plate to 55º to remove supports. Oops Otherwise they were super popular at a recent market. - 3d model

Clicky Cacti

Clicky Cacti - Printed the pots on a Bambu A1 Mini & the caps on A1. Used SuperTack plate for both & had no adhesion issues. After printing the ones in the photo, I set the seam to back so that it would not have a disjointed seam on the pots & instead has a seam straight down the back. Filament used: ERYONE Olive Green, PolyLite Cream, ERYONE Red Matte, ERYONE Matte Pottery Red - 3d model