Doreen S
Awarded to:eddysnores
First Make published
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
eddysnores’s profile picture

eddysnores

0 followers0 downloads

Achievements

50 Models downloaded badge
Voyager
50 Models downloaded
First Make published badge
Novice Maker
First Make published
All
Sort by:

8x4 MU

8x4 MU - Used 4x4 full edge and 2 4x4 side-by-side pieces for the long sides. This thing is super difficult to assemble. The H clips are super tight, I had to remodel the small tool larger bc my hands can only squeeze so much. No clue what the holes on the bottom are for. Be nice to see photos of the pieces being used and not just a pic of the piece itself. Most of this stuff is FAFO and hope it does something useful. Good luck! - 3d model

2 MU

2 MU - Box worked great. Was tricky assembling, but much easier with the tool shown. I used PETG for the dark blue H connector pieces, need to jam those in both sides of each piece twice so print 32 of them. There are 6 in each corner piece. I used a 4x4 plate for the bottom, a 3x3 plate is too small. - 3d model

3x3 MU

3x3 MU - Putting that 3x3 box together was no joke. Little H connectors are tight and must use the tool. The 4x4 plate fits in the 3x3 box (kinda strange). I'm still searching for attachment instructions, or is this even the correct part? - 3d model