Introduction Hi there!

My name is Eduardo, and I am an Amateur 3D Modeler from Brazil.

This is my model of a retro keyring pixel art from Pokémon!

Please use M600 (Filament Change code) to swap between colors and make a beautiful piece of art.

If you like this one, I look forward to make more of it.

Print Settings 0.2 Layer Height

15% Gyroid Infill

35mm/s Speed (Ender 3/Neptune 2s)

Configure M600 between colors (check guide).

Thank you for downloading my model, I really would like to see your print if you care to share it!