Headphone Rest - v3 (for Laptop, Notebook)

The goal of my design is to create some kind of rest or hook for a headphone / headset while you are working on your notebook/laptop.
My headphone was always laying arround and i wanted a cleaner desk.

The headphone rest have to be placed / double tape glued onto the backcover of the notebook/laptop.

The headphone rest can be slided out to hang on your headset to the hook and if you put your notebook/laptop in a bag for travel etc.. you can just simply slide the rest in.

The example pictures will show you where to place it and how to use it :)

If you like my design, i would appreciate it if you buy it to support me for my time to create it and make future designs possible.

Note: Double side tape - i used a 0.8mm thin double sided tape with a width of 30mm (which fits perfect for the design), you may use a 3M or a similar tape from amazon, aliexpress, local store etc.

Befor you glue it onto the notebook/laptop - make sure both have temperatures > 20°C and the spot where you tape it onto the notebook/laptop is free of dirt, dry and cleaned (like with isopropylalcohol ...) to get a nice bond. (Make sure you do not damage the backcover by the material used).

If you like the design, you can fill out the offset surfaces with a white/colored waterproof pencil to give it a highlight.


Print material: PETG (recommended)
Nozzle size: 0.4mm
Layer height: 0.16mm or 0.12mm works perfect. (maybe 0.2mm works too, but i have not tested it since the parts are small)
Print duration: 1 set (base + slider) was 42min on my Prusa MINI+

Postprocessing:
- Place the double sided tape on the back of the base
- Put a very very small dip of grease / oil onto the "inner rails" of the base
- Connect the slider into the base with a little force to "snap in"
- Try to move the slider from side to side, if it runs smooth all good, if not, maybe a little sanding/mechanical smoothing is needed.

Ender 3V2 Hotend Fan Cover Housing Duct

Marsgizmo Filament Bunker v3 - Lid_rev2.stl

Remix of Marsgizmo Filament Bunker v3 - Silica Lid

Improved some corners and the grid for smoother and faster printing + a little bit more stability.

e-soni

Achievements

Seedling

Fan Favorite

Headphone Rest - v3 (for Laptop, Notebook)

Ender 3V2 Hotend Fan Cover Housing Duct

Marsgizmo Filament Bunker v3 - Lid_rev2.stl