Sharing my simple vase mode planter.

Basic print settings:

• Vase mode on
• Outer wall 0.62mm recommended

I provided couple common inner sizes like 12 or 16cm, but since it's very minimal design, it can be scaled to fit your pot.

It's designed so that you put the plant already in pot into this model. Not to put the plant with soil directly to it. I mean use something like this.

It's not watertight. I provided saucers that I use and put on the bottom. The saucers can be made watertight. I provided a profile with increased temperature, slower printing and increased flow ratio. This will make it more watertight. For better results use petg, which has much better layer adhesion than pla. If you want to be 100% sure, spray the saucer with acrylic laquer.

Plant supports used on the photos. Hanging version of this planter.

Commercial licence available on Patreon or Makerworld