SP03L continues the line of 3D printable lamps that gives new life to filament spools.

Those of us who print know what it's like to have spent spools lying around not knowing what to do with them, plus they're hard to recycle. That's why I've created this design line that cleverly plays with the spools to get the most out of them.

This DIY design is intended for filament spools equal to those shown in the images, that is, ELEGOO cardboard spools with three holes. Although if you have identical spools of other brands you can also use them making sure that the piece is well inserted through the hole.

To mount it you have two options, depending on the size of your printer. If your printer can print up to 370 mm height or more you only have to print 3 times the same piece (SP03L.stl). Otherwise, you will have to print it in halves (HALF-SP03L.stl) which are then easily inserted (you can also secure the joint with glue).

This design incorporates paper as a novelty to further enhance the sustainable nature of the design by using less plastic. It is intended to incorporate a cylindrically wrapped A3 size sheet (to form the cylinder, simply tape the ends together). This paper cylinder is inserted between the grooves of the pillars that have been inserted into the coil (remember to mount the wire and the bulb before).

For more clarifications you can stop by my Instagram where you can ask me personally, also I will be posting more information about the project: https://www.instagram.com/creaserra