Firewood is a fully 3D printable table lamp design.

Its design has been inspired by a curious curved geometry that has been distorted to form a trunk that will set your home as if it were a wood fire.

Its assembly is simple and intuitive. After printing the two pieces and buy the cable and socket for the bulb just pass the bulb cable through the hole in the base, screw the disc or stopper to the socket, screw the bulb and finally place the body of the lamp coinciding with the slot in the base.

Here is the link to the cable and socket I bought: amzn.to/450MBgY

For the bulb any E27 model would do, being able to play with the intensity or warmth of the light.

For more information and explanatory videos you can visit my instagram: https://www.instagram.com/creaserra

3D PRINTING PARAMETERS The printing of each of the two pieces is done with a recommended layer height of 0.2 mm although I could use a higher layer height for the printing of the body.

The body (leña.stl) should be printed with transparent plastic (I used transparent PLA of the 3DJake brand) or you could even use white if the bulb is very bright. This is a solid model and has two options to print it, both with 0% infill, wall line count: 3 and top layers: 0 and no supports:

Bottom laters: 0 so that the end lamp is open at the top. Bottom layers: 5 so that the final lamp is covered at the top. For the base (baseleña.stl) it must be printed in the reverse orientation (legs up) and using support for the slot. For this piece I used a 20% infill and a green matte PLA but you can use any color you want.