This is a design based off of @3DDIY Dave's french cleat coat hooks, and redesigned to work with the Matt Eskuche claw grabbers for Glassblowing.

Dave's design is meant to be used with a french cleat that is 3.5 inches wide and cut to 45 degrees on both sides. This prevents the tool holder from coming off the wall with your tool when you grab it. I think this will work fine with a cleat exactly 3.5 inches wide, but I cut mine a hair shorter to ensure that nothing grabs or sticks when I move it from side to side.

This should print out just fine on its side, however it will need supports for the gap the tool sits in. 

Kuchekup Claw Grabber French Cleat Mount

claw grabber french cleat V1.3mf

This is an insert for the original Texas Instruments SR-56 calculator battery compartment. It allows you to take out the old (and probably leaking/non-functioning) rechargeable batteries and insert your own replacement lithium battery and charger.

I started this project while looking for ways to repurpose batteries out of the disposable vapes that are popular right now. I'd been harvesting the batteries for a while, and an old SR-56 was the first thing I experimented with.

The battery is just a generic lithium battery about the size of a AA, I can't link it specifically because I harvested it from an old vape.
The charge controller I used is this one from Tayda electronics I happened to have on hand: https://www.taydaelectronics.com/57170-dup-tp4056-lithium-battery-charge-control-module-dc-5v-1a-with-protection.html

It looks like at one point the original battery pack had pieces of plastic spanning across its length, however I received mine with these already broken off. If yours are already broken, or you don't mind breaking yours off on purpose, then this case simply sets right in to where the old batteries went. I secured mine with a piece of double sided tape and that was it.

I did decide to drill holes and screw my charge controller down instead of gluing or taping that. I was able to re-use a couple screws that came out of the same vape I disassembled to get the battery.

TI SR-56 Lithium conversion adapter

Battery Conversion V5.3mf

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

coolnerd11

Achievements

Voyager

Seedling

Novice Maker

Kuchekup Claw Grabber French Cleat Mount

TI SR-56 Lithium conversion adapter