this is a pen holder that spins. 
prints without supports.
print main part upside down.


revolver cylinder pen holder with a twist  

gun barrel pen holder v2.stl

key chain phone stand v6.3mf

key chain phone stand3 v1.3mf

this is an led light bar for Ender 3
just mirror the mount to print the other side.

there are two different mounts one is just for a printer without the spool mount i designed.
the other is designed to fit right next to the spool holder keeping a clean look. 

the light bar itself can be split in half in order to 
print it on an Ender 3 and then glued back together.  

uses a 10/32 by .5" countersunk screw. 

the holes in the extrusion will need to be tapped.

 just make sure to take out the screws the hold the top extrusion in place or you wont get the tap deep enough 

wires will be ran inside the mount and down the back of the printer. you can run the wires down a slot the put a cover over it to keep everything in place

Ender 3 light bar

ender 3 LED side mount WITH SPOOLHOLDER.stl

ender 3 LED side mount WITHOUT SPOOLHOLDER.stl

replacement filament holder for ender 3
uses two 4mmx8mm countersunk screw with two 4mm t-nuts.

prints without need of supports

Ender 3 spool holder.stl

new ender 3 filament holder.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

codepentecost

revolver cylinder pen holder with a twist

key chain phone stand v6.3mf

Ender 3 light bar

Ender 3 spool holder.stl