Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2936837.

Simple thing to hold organization boxes.

Box Slides

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3537554.

Some parts to replace bad / broken parts on my cheap drill press.

Cheap Drill Press Components

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3183204.

Simple toolholder for a french cleat wall, using PVC pipes.

The bottom part is glued to the pipes with cyanoacrylate, and I poured in sodium bicarbonate to fill the gaps and help set the cyanoacrylate, and then poured out the remainded.

Cutting the pipes straight was the hard part :P I ended up just using a small metal hacksaw, and going slowly, clean up with a dremel and some sand paper, and then smooth the edge with a lighter.

French Cleat Tool Holder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3484806.

A box to mount an arduino featherboard with a DHT22 sensor to a wall. Still a work in progress, pictures will follow.

DHT22 Feather Enclosure

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3284176.

Rail system to mount Sortimo T-Boxxes.

Inspired by watching the Tested video on [Inside Adam Savage's Cave: The Tool Boxes](https://www.youtube.com/watch?v=1OPSbF6kM9k)
 Sortimo system, I bought 5 of my own. These boxes ROCK!

I could not find any way to mount them, as in Adam's video, so I created some rails to mount them in my work bench.

The spacers are to put the rails at a proper distance from each other so the boxes can slide in and out.

The width between the side panels is 45cm

T-Boxx Rail

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2968242.

Still a work in progress...

PrintDry Filament Feed System

Activity related to collaborating with others on models

Likes, comments, and activity from your community