A decorative topper for your Christmas tree. All parts were printed on a P1S printer with 0% infill, 2 walls, with a .1mm layer height. The tree topper halves were printed with tree supports. You will need to print two tree topper halves one tree topper rim and one tree topper base. The tree topper base should simply hold the two topper halves and rim together without glue. I experimented with two different light sources, one being a 10ft monster led rgb light strip, the other being a 16ft fairy rgb light string. Only 5ft of the Monster led light strip was used. A small zip-tie was used to secure each light to bottom of the topper rim. A drop of super glue was applied to the other end of the Monster led light strip to secure it to the topper rim.