Awarded to:bryan.murphy0001

First Make published

Oct 17, 2023 · 1:30 AM

bryan.murphy0001

0 followers0 downloads

Achievements

Novice Maker

First Make published

Voyager

50 Models downloaded

Sort by:

Universal Pliers and tool Holder and cable management Multiboard remix

Universal Pliers and tool Holder and cable management Multiboard remix - I sliced off the bottom so I could print it in the shown orientation. No functional issues with the shown prototype (printed at 200% speed). - 3d model

Articulated Mech — Zenith Arbiter ZA

Articulated Mech — Zenith Arbiter ZA - I tried to print twice and both failed. The first was my fault, I was pushing my luck with my quality settings, no glue, and zero supports. The second print was coming along great until the bottom part of the shoulder joint (the ball) popped out of the socket mid print. Any ideas how to mitigate that happening again?

I took a closer look. The ball on the left was very clean and round. Came to a crisp point touching the base. The ball on the right was very sloppy and there were some stray strands underneath it. I think it failed almost immediately, probably because the point touching the base is so small.

Perhaps making the ball a little flatter would help? - 3d model

Halloween Ghost Cat Trio.3mf

Halloween Ghost Cat Trio.3mf 3d model

Halloween Ghost Cat Trio.3mf

Halloween Ghost Cat Trio.3mf 3d model