Quad Lock Magnet Holder.stl

Based off of the design made by https://www.thingiverse.com/tiago199988

Added some wings due to only having 12mm magnets on hand.

Press fit 4x 12x3mm magnets on the 4 wings, and the center magnet hole fits a 12x2mm magnet.

Holes are sized to 12.1mm to have a little wiggle room, I didn't need to use glue but YMMV.

Print settings:
Infill density: 10-20%
Support: yes (tree)
Layer height: 0.2mm

I printed with the holes facing the bed due to the supports making the bottom of the wings look terrible, but depending on your config you may be able to print upright.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

braydenburr

Achievements

Seedling

Quad Lock Magnet Holder.stl