This version is without luck, but with love, faith, and hope ❤️

Easy to print, no supports ✅

4mm hole for keychain 🗝️

For the best results, use matte filament 🔥 (or better yet, two-tone matte filament like mine). If you look closely at the clover leaf, you'll notice that the layer lines are not parallel but instead converge toward the center, forming a natural pattern. A layer height of 0.2 or 0.24 mm works perfectly for this design.

Don't forget to give me a like Share photos of your prints ☘️

Personal use only⚠️ 👉 Check My Patreon 👈 your support is important to me 🫶

Sometimes it's hard to find a flexible four-leaf clover, but believe me, it exists too 🍀🤫