20210409_Remote_Holder.stl

An organizer to hold remote controls upright on a side table. The pockets measure 25mm by 46mm and are 47mm deep. Wings are added to the base for a bit of extra stability. Fits standard Roku remotes and Samsung device remotes.

20210331_glue_stick_alcohol_holder_v2.stl

I wanted to keep my glue stick and spray bottle of isopropyl alcohol near my printer, so I designed this holder to slide into the horizontal V-Slot on my Ender Pro 3. The holder is designed to fit a 30mm diameter XL Glue Stick and a ~32.2 spray bottle for bed cleaning or other purposes. Prints as one part and works with no additional hardware.

20210324_Icom_mic_vent_clip_vertical.stl

Designed as a no drill, no adhesive solution for hanging Icom microphones in a vehicle. This design clips into automotive vents with vertical louvers. Check my other designs for a clip intended for horizontal louvers.

Please leave me feedback if you like the file.

I intend to sell these at local hamfests, so please do not sell them for yourself. Feel free to make these clips for personal use or gifts.

20210324_Icom_mic_vent_clip_horizontal.stl

Designed as a no drill, no adhesive solution for hanging Icom microphones in a vehicle. This design clips into automotive vents with horizontal louvers. Check my other designs for a clip intended for vertical louvers.

Please leave me feedback if you like the file.

I intend to sell these at local hamfests, so please do not sell them for yourself. Feel free to make these clips for personal use or gifts.

I am an experienced 3D designer and new to 3D printing. Amateur radio has motivated me to apply my work skillset in the rest of my life through 3D printing.

benanseen

Achievements

Seedling

20210409_Remote_Holder.stl

20210331_glue_stick_alcohol_holder_v2.stl

20210324_Icom_mic_vent_clip_vertical.stl

20210324_Icom_mic_vent_clip_horizontal.stl