I made this to replace the Pavo Pico frame. Just take off your press nuts on the old frame with a soldering iron and push them in the new frame and screw it on.

Pavo Pico Replacment frame

Picoframe.stl

I made this for drones to fly and not have to worry about breaking the camera.
Use a small strap to install from side door and pull out with strap for easy use

DJI Action 2 protective case gopro mount

djiaction.stl

Add supports to bottom only do not let them in the drone or you will never get them out

Avata Ornament 

avataor.stl

Make supports on bottom only do not let them get inside the drone

Avata Keychain

avatakeycha.stl

This is the TPU part of the

https://www.youtube.com/watch?v=-8oY83eVwng

DJI FPV Rescue Claw TPU

djiclaws.stl

This was made to rescue other drones 
https://www.youtube.com/watch?v=-8oY83eVwng

DJI FPV Rescue Claw PLA

THECLAW.stl

Freestyle Five33 DJI 02 & 03 unit and HGLRC M100 Mini GPS

freefive33.stl

Aerodynamic DJI Action 2 case strap mount

I built this so we do not have to spend thousands trying out 3 drones to see what is right for you. Now all you need is a 5 inch drone and 3.5 inch props. The whoop mounts under the motor and the skirt slips over the prop guard. This is called the "Atradies Whoop" 

5in Cinewhoop Conversion to 3.5in Adjustable Duct

Tanq Drone Dragon Set

Tanq Drone TPU set all works together. They all have a purpose. The front is for ram air the sides protect the flight controller and this allows you to have a fully enclosed tanq drone and not have to worry about zip tien anything down.

Tanq Drone TPU Set

Working bolt set it will thread on if you have any trouble try a dab of chapstick

4mm bolt and nut pla WORKING

$mm bolt and nut pla WORKING

The Support and the male piece both need to be printed TPU and the spoilers PLA. Then the male dovetail gets pressed onto the spoiler with a flathead screw driver. This is not easy  but very very durable and will survive crashing. I print at 30% infill on everything.

Advance Adjustable FPV Spoiler Set

This is a simple print for spoilers for drones

Simple Spoiler package FPV Drones

FPV Adjustable Spoiler 180*

Very good and durable whoop. I designed this to be able to add to 5 inch drones with strength aerodynamics in mind. 

3.5 inch Cinewhoop 89mm

This is a dragon tail for the Rotor Riot tanq and it has a runcam mount on the end of it for TPV camera

Tanq_Dragon_Tail_runcam.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

atradies.operator