Kenwood D700A Mount Blank For Remixing: Part J29-0663-13

I had been looking for a while to see if someone had uploaded some type of mount for the Kenwood D700A ham radio. I could never find one, so I decided to draw one up.
This is a work in progress, although it worked for me right off the printer.
It's basically a blank Kenwood mount for use with remixing.

Here is the original part. Kenwood J29-0663-13
https://www.gigaparts.com/kenwood-j29-0663-13.html


Xiegu G90 Stand Remixed To Be Stronger And Sleeker - KD5QZG

Thank you so much to inlinerbutch who made the inital stand that I remixed from!
This is a fantastic stand that folds up nicely to pack up my G90 .

Unfortunately there were some sharp right angle corners on the stand that happened to snap while in my bag and broke the bottom corner of the stand off, as well as snapped off one of the edge stops that hold it up when deployed.

I brought it into Fusion 360 and re-drew and remixed the model to have way more rounded corners to reduce the change of it snapping in two.
That was the only thing that was really missing from this great design that inlinerbutch created.

73 KD5QZG


Mic Hanger for my Icom 7300 for 16.2mm thick shelf 

Half Inch PVC Tape Measure Yagi HT Radio Holder

I recently made a 2m yagi tape measure antenna out of 1/2 inch schedule 40 PVC pipe to listen to some satellites pass overhead. I quickly realized that it would be easier to mount my radio on the antenna for ease of handling. This is an original design I made using Fusion 360. I needed a project to help me learn it ;)
I currently have a Baofeng UV-5R clipped to it, but it should work with most belt clip HT radios. I even made a coax clip which should help keep the cable tidy while using. It snaps tight and seems to stay in place really well on the pipe. Enjoy!

Here is the Fusion 360 file for anyone who wants to customize it.
https://a360.co/2V4zHNO


Disc Mount Socket that Pops With Blank Back for Remixing

This is a Disc mount with a blank backplate to be remixed onto any type of mounting bracket you would like. I modeled it from scratch in Fusion 360. This was my first project in Fusion. The bottom connection of the backplate to the ring is pretty hefty so that it won't break the ring off due to vibrations in a vehicle. I'll post any updates as I make revisions.

adammelancon

Achievements

Seedling

Kenwood D700A Mount Blank For Remixing: Part J29-0663-13

Xiegu G90 Stand Remixed To Be Stronger And Sleeker - KD5QZG

Mic Hanger for my Icom 7300 for 16.2mm thick shelf

Half Inch PVC Tape Measure Yagi HT Radio Holder

Disc Mount Socket that Pops With Blank Back for Remixing