Fred the Frog but a large magnetic container

I wasn't sure about printing the existing screw-fitting Fred container at large size and I thought it'd work well using magnets to attach the lid.

This is created from the “resculpted” version of Fred the Frog.

https://thangs.com/designer/Xx_SushiCat_xX/3d-model/Fred%20The%20Frog-51739

It requires eight 6x2mm magnets which should “push” fit into the holes with a tiny bit of force and then hold. If not you may need to widen the holes slightly and/or use a tiny dab of glue on the magnet.

To print it smaller you'd need to replace the magnet holes.

I originally intended to create a lip around the hole which would fit into a recession in the head for additional stability, but meshmixer did not want to co-operate.