My take on an aerosol can holder for Multiboard. This was inspired by @ne2000 and his version here.

I wanted to make a version that did not require supports for printing and also allowed me (in true Multiboard tradition), to mount the holder using a multitude of different clip variants 😁

I also found that I had a couple of slightly larger aerosol cans that were very tight fitting in the @ne200 version, so I decided to open the front end and add a bit of "grip" to the can via the holder.

I use a single OXO Lite Rail clip for attaching to Multiboard. My goto choice is a Pegboard Click OXO Rail Pop-In. This seems fine even when yanking the cans in and out. I have also tried a OO MP Bolt-Locked insert, but this seems overkill for my use.

I printed with 3 wall loops and gyroid infill.