profile hero image
Willi 3D’s profile picture
Willi 3D’s profile picture

Willi 3D

Jacob C
Ryan M
Maker M
1,385
Jacob C
Thangs 3
2
52,650
12,555
29
3,677

Designer posts

Updates and new releases

Updates and new releases

Two more inserts have been available for the BaBo system since last week.I designed another variant of the top mount for the BaBo duo AMS drawer stacker. This allows the top stacker to open the lid completely like the stackers below. Of course, this variant requires more space. I also designed the

Improvements for [BaBo duo] modules

Improvements for [BaBo duo] modules

I have made some improvements in [BaBo duo] modules.Updates:[BaBo duo] mono drawer module 30-guides changed to reduce noise when pulling out-front look changed[BaBo duo] mono drawer module 60-guides changed to reduce noise when pulling out-front look changed [BaBo duo] plate module (x3 & x5 ver

Update: [BaBo duo] AMS drawer stacker

Update: [BaBo duo] AMS drawer stacker

Hello people, I have finally found a solution to hold the AMS lid in place when changing materials that I like. (Is published) -no more magnets needed -works within the stacker and therefore does not need a stacker above -there is a version for the top mount variant in which the lid is only opened

Updates 
[BaBo duo] AMS drawer stacker

Updates [BaBo duo] AMS drawer stacker

- rear x member revised to simplify the guidance of the PTFE tube, making printing and assembly easier.- wall support mount revised to make it more stable.- added another smaller PTFE tube connector holder version

[BaBo duo] AMS drawer stacker V2

Hey guys, I completely redesigned the [BaBo duo] AMS drawer stacker (who actually comes up with these unnecessarily long names? 🤨) based on your feedback. Above all, the focus was on assembly and stability. That's why the AMS can now be removed and installed at any time. Furthermore, there is now