A cosplay replica of Coco's Ink Wand, as seen on the "Witch Hat Atelier" series.
The wand body is one piece, with no supports required if printed upright. Included is a version without the diamond pattern if you are gonna hand paint the wand instead.
I recommend doing a manual filament swap at the base of the diamond pattern/neck section. And one more once you start the ornamental end of the wand.
The diamonds for the neck section should press fit in place. The biggest diamond goes in the slot next to the widest section of the neck. The nib is a bit loose in case it breaks. This makes it easy to replace without printing everything again!
If scaling, scale everything evenly.
Test fitment of the parts, as you may want to sand some of the surfaces before applying adhesive. This can ensure a better bond. Always use PPE when handling harsh chemicals or strong adhesives.