Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3903334.

Designed my own lead screw guide as I wanted to mount it on the top of the frame. Fits a 608 Bearing.

Lead Screw Guide

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4355414.

Railed front handguard for an airsoft AK47. Was modelled around my bulldog AEG AK47 so the fit may vary between models.

Print in the orientation it would be mounted with support underneath. Make sure your retraction is tuned properly so it isn't too weak.


Airsoft AEG AK47 Hand Guard Rail

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3956302.

Because your breakfast biscuits always break.

There are 2 versions, one to fit 2 biscuits and another to fit 4 biscuits.
You need a "Big Side" and "Small Side" for a container.

Currently only have pictures of the container that fits 2 biscuits.

Can be printed on either side of the small sides. Support could make printing better.

Breakfast Biscuit Container

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4099368.

I created this simple piece to help align MGN12 linear rails into the centre of 2020 aluminium extrusions. I have rails coming in the mail so I haven't tested it yet but I used dimensions from the Hiwin website and the extrusion part fits so, in theory, it should fit. Please leave a comment if it does not fit.

You can print 2 and put one either end of the rail to centre it.

MGN12 Aligning Tool

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3903325.

Bed levelling knob designed for 11mm outer diameter circular bed nuts. 

Bed Levelling Knob

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3460093.

A spool holder to be mounted on the top of the frame of a printer. I have been using this personally for a while to hold the spool above my printer. Over time it has sagged a bit but doesn't seem like it will fail. Was made to hold 1kg spools but could hold smaller.

Spool Holder for 2020 Aluminium Extrusion

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow