Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860740.

I plan on raising up my 5 plus by 100mm to drop the power case under the extrusion so i can put an enclosure across the top of the lower extrusion and keep the case and Z motors underneath the lowest sheet of enclosure.
i put in some holes to the riser feet so possibly i could fit the stock silicon feet to these.
the idea being that this screws to the 2020 extrusion using M3 T-nuts i think. 

Creality Ender-5 Plus 2020 extrusion 100mm riser foot for each corner

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860720.

A Hanger designed to be able to run a PVC Flexible Ducting Hose (100mm in diameter).


100mm Duct Hanger

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860747.

i planned to print this to join my Manrose 120mm Round Pipe to Rectangular Channel Connector to my Manrose 125-100mm Round Central Reducer for my ducting setup

120mm inner joiner for Round Pipe

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860727.

A Fume hood i hope to print soon to extract smells from my print area and from solder and dremeling. 
This is designed to fit a 100mm flexi duct hose

100mm Duct Fume Hood

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860730.

fume duct hood inner to clamp the 100m duct so the hood and inner can hang from the duct above where you want the fumes extracted from

100mm Duct Fume Hood inner

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4860752.

joiner designed to join a Manrose Round to Rectangular Appliance Connector Elbow 90° Bend White 125mm to a Manrose Round Pipe to Rectangular Channel Connector White 120mm


Rectangle joiner for 204mm channel connector

designed to allow better air flow than sat on the desk, but also not too angled so that the typing ergonomics aren't aversely affected

HP zbook stand

Cradle to hold my 6 pro in its phone case in our car phone holder.. the kids like to watch tv shows and the phone kept on falling out of the holder because of my case, so knocked up a cradle so it fits snug to both.
this is my design.
for personal individual use only, not to sell.

Google Pixel 6 Pro cradle for a car phone holder

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Tranquillity_Prototypes

Achievements

Seedling