Thomas H
Thomas H

Cute ornament gnome

by
ThomasH
ThomasH
Follow
ThomasH
ThomasH
|
Image 1 of 4
Cute ornament gnome 3d model
ThomasH
ThomasH
|
Image 1 of 4
Cute ornament gnome 3d model
2D
3D
Makes
Cute ornament gnome 3d model
Cute ornament gnome 3d model
Cute ornament gnome 3d model
Cute ornament gnome - Have a whole crew in Harley colors  - 3d model

Cute ornament gnome

Print each part, see print instructions. Cut away the wall from the beard with a knife. Assemble the parts and then use a hair dryer/hot tap water to slowly heat up the beard while you use a hand to form it.

For most control, use water. For crazy beard, use hair dryer. Be careful not to burn yourself.

Tip: put the hair dryer on the edge of a table so you can use both hands.

After you have formed the beard, you can use scissors to make some final adjustments.

Print instructions

All parts has been optimized to not need any support. The overhang on the body is 45deg.

The beard should be printed with a 0.2 layer height.

The beard prints better with the classic perimeter generator in prusaslicer.

Support / Reseller

If you want to support me or sell my models, take a look at my Patreon:

https://www.patreon.com/thomash3d

You can also send me a tip on paypal:

https://www.paypal.me/thhen


80 Likes202 DownloadsDecember 11, 2022
This model is restricted by licensing terms.