2x7 WallControl to 1x4 Gridfinity Adapter

I combined a few model's geometry to make a 5 part assembly into a single part.

https://thangs.com/designer/notsam/3d-model/2x7%20WallControl%20to%201x4%20Gridfinity%20Adapter-63060

https://github.com/aderusha/DDD-Printable-Wall-Control-System

I like the Gridfinity system a lot, but I was frustrated with the end quality of using the DDD wall control brackets along with this adapter, so I made them into a single part. My version also prints with no supports or assembly required.

Print with the "Top" side down and use an arachne based perimeter generator because there's some thin walls on the first layer. I would also recommend printing the first layer slowly (10mm/s) to ensure bed adhesion, as there isn't much surface area.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

The_Ultimate_Gamer

Achievements

Seedling

2x7 WallControl to 1x4 Gridfinity Adapter