This was created to replace a missing drawer pull on a vintage dresser.

For best results, print with the back face (the side against the dresser drawer) down. The hole is pre-threaded, no need for tapping.

Configurations currently available:

• 2 holes, 25.3mm apart, pre-threaded for (I think) M4 x 0.7
• 2 holes, 32mm apart, pre-threaded for M3 x 0.5

If you'd like a different thread/hole configuration, leave a comment or send me a message and I'll get it added for you.

--

If you like my work and want to support me, please check out my online store or become a patron. Thank you!

--

Licensed for personal use only. Commercial licenses available here. Please do not redistribute this file or any modified derivatives of this file in any way, or sell your own prints made from this file. Thank you.