Spinmaster Paw Patrol Lift

pawpatrol lift.3mf

Argos wardrobe connector

Friend had some broken connectors for this wardrobe https://www.argos.co.uk/product/7627716?cmpid=APP003&fbclid=IwAR29A85ypaHeQptG6tKUvRIhcYLznY-IRAL4iL15_jzzkVwUQQCjczCWFrM

designed some new ones :)

Fiesta mk6 vent ring

perfect fit for fiesta mk6 vent ring, just use some sticky tape to hold them in place.

i have the type that dont easilly pull out and it looked like a pain to have to dismantle the whole dash to replace them. this just sticks on top and looks cool. i dont likle the silver bits and am wokring on replacing them all with 3D printed parts.

Fiesta mk6 & ST150 Cup holder insert

Back again with a nice print for the Fiesta mk6/ST150 owners.

Love my car, the plain black bits are boring. this cupholder is nice, just pops in, stays in place and gives the car a little nice detail.

64mm is a perfect fit. not too tight yet doesn't wiggle about.

Change colour at layer 9 for the accents.
The ring and logo sit flat, so your cup is still stable.

All i ask is that any prints arent sold on a commercial scale.

7 inch radio frame

upgraded my fiest mk6 to have a android head unit in, looked great but had big gaps around the outside. this is used to cover the gaps. 

Fiesta mk6 coin tray

Fits nice in the coin tray bit of a 2005 mk6 fiesta, i believe it should also fit in a ST150. i cant confirm this however. i reccomend a small amount of tape/rubber feet stuck to the bottom just to stop it sliding about.

Gaiter Ring Fiesta MK6 - ST150

The standard gaiter ring on my 2005 Fiesta was a bit tatty, so i designed a new one to print in the same blue as my car!

Easilly remove the old one bu pulling up on the black ring around the gearstick, and then pry the standard silver one off by running your nail around the edge.

the clips can be a bit fragile so i recommend a lil bit of double sided tape just to keep it in place.

Steaky3D

Achievements

Voyager

Seedling

Debutant