Those horns look great! I'm glad you were able to utilize our headband system so easily. Thank you for sharing!

Finally found m3 locally! Do you use superglue to help the nuts not move?

Would there be any way to do a version of the clips with more readily available hardware/nuts? Unfortunately every hardware store I've been to doesn't have smaller than M4...

Have a question about commercial licensing but only if there are specific ears and horns available too. Looked at store info but couldn’t  see where to message 

This is our Headband of Disguise. We designed it with cosplayers, costumers, and casual nerds in mind. Our design features several fantastic attributes that make it the ultimate utility for head-worn accessories:  
- Accessories can be placed in **various places along the headband**.
- Accessories are mechanically connected with keys that can **rotate and be tightened to any angle**. 
- The holes are counter-sunk to allow the **screws to sit flush with the headband**. 
- The headband can be **hidden underneath a wig** and the accessories clicked into place on top.
 
[  Buy The Official Starter Kit Here ](https://shadowfallworkshop.etsy.com/listing/1520652729/headband-of-disguise-add-on)
&nbsp;
[ Our Etsy shop has a ton of compatible accessories!](https://shadowfallworkshop.etsy.com)
&nbsp;
**Contact us for Commercial Licensing**

[Headband of Disguise Instructions](https://shadowfallworkshop.com/headband-of-disguise-instructions)

---

NOTE: These files are best opened with PrusaSlicer 2.6.0+

---

**Headband:**
We have 2 sizes of headband. The standard size fits most adult heads, up to 24.5 inches in circumference comfortably.
Print Settings:
- Filament - PETG
- Nozzle - 0.4mm
- Layer Height - 0.25mm

Try to print the headband with the least amount of "Elephant Foot Compensation" so that the comb prints properly.

---

**Keys:**
The keys are the most integral part of our headband system.
Print Settings:
- Filament - PETG
- Nozzle - 0.4mm
- Layer Height - 0.15mm

Necessary Hardware (per key):
- [1x M3 Nylock Nut](https://www.amazon.com/binifiMux-100pcs-M3-0-5mm-Nylock-Locking/dp/B07FRLRWD4)
- [1x M3 Flat-head socket cap screw](https://www.amazon.com/Socket-Screws-Countersunk-Threaded-Assortment/dp/B0BYXPZHC5)

You should be able to find these at your local hardware store!

--- 

**Key Boolean:**
We are also releasing the model to create a Key-hole in any project that might benefit from the Headband of Disguise.
Simply add this model as a "Negative" to your creation and the resulting keyhole is the perfect fit!
Just make it has the correct measurements when the model is imported:
- X - 12.04 mm
- Y - 08.14 mm
- Z - 13.79 mm

---

**Headphone Mount:**
This is a new addition that can be used to add our keys to your favorite pair of headphones!
Print Settings:
- Filament - PETG
- Nozzle - 0.4mm
- Layer Height - 0.15mm

Necessary Hardware:
[Velcro brand 1/2in wide cable ties:](https://www.amazon.com/VELCRO-Brand-Cable-Ties-100Pk/dp/B001E1Y5O6)

---

**For non-commercial use only. For commercial applications send us a message!**

Discussions — Headband of Disguise