Ruven B

Spin Ball

by
RuvenBals
Follow
Follow
Remix Model
RuvenBals
RuvenBals
|
Image 1 of 6
Spin Ball 3d model
RuvenBals
RuvenBals
|
Image 1 of 6
Spin Ball 3d model
2D
3D
Makes
Spin Ball 3d model
Spin Ball 3d model
Spin Ball 3d model
Spin Ball 3d model
Spin Ball 3d model
Spin Ball 3d model

There are 2 versions, one with only printed parts and one uses regular skateboard bearings.

All Printed Version: You need: 8 Gears 1 Heart 8 Connectors

You can just print the All file.

Print settings: no supports needed. Just print with a standard profile. I used a brim for better bed adhesion.

Assembly: Push the connectors into the heart and then put the gears on top.

Bearing Version: You need: 8 Gears 1 Heart 8 Regular skateboard bearings like these: https://shorturl.at/Z0V1T

Since this version is very tolerance-dependent, I provided many different versions. Start with the 8mm and 22mm version and if that does not fit, go bigger or smaller. Make sure to use the actual filament for the test.

Print settings: Use supports for the gears. The heart does not need supports but maybe a brim.

Assembly: Push the Bearings in the heart and then the gears into the remaining hole of the bearings.

Leave a like if you can :D


118 Likes946 DownloadsJune 10, 2024


118 Likes946 DownloadsJune 10, 2024