Ruven B

Sierpinski Fractal

by
RuvenBals
Follow
Follow
Remix Model
RuvenBals
RuvenBals
|
Image 1 of 11
Sierpinski Fractal 3d model
RuvenBals
RuvenBals
|
Image 1 of 11
Sierpinski Fractal 3d model
2D
3D
Makes
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal - This model is incredible! Take a bit to print but well worth it - 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
Sierpinski Fractal 3d model
This model is restricted by licensing terms. 

Hey, this download contains various Sierpinski Fractals. Inspired by this model https://www.thingiverse.com/thing:1356547

I made various levels of detail. The higher the Level, the more detail, but be careful these models cannot be scaled down if you use a standard 0.4 nozzle and 0.2 mm layer height. So choose something that fits your printer.

I printed the 5 LVL with a stand. That's the one shown in the picture

Slicing: All variations Slice the same. No supports needed.

Use vase mode. Vase mode may be called differently in your slicer. In Orca Slicer it's called "Spiral Vase" and "Smooth Spiral" make sure to check both. I scaled them for you to be printable with a standard nozzle and layer height. Only scale them down if you go below this layer height. They might not slice any smaller. Scaling them bigger is not a problem.

I presliced a few in Orca Slicer. If they don't open in Bambu Studio try Orca Slicer it's better anyway.

Have fun and don't forget to post a make ;)


62 Likes268 DownloadsOctober 18, 2024


62 Likes268 DownloadsOctober 18, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density0 %
SupportsNone
BrimNo