This model is restricted by licensing terms.
View license.
Hey,
This is a print in place. No Assembly required.
Print settings: Standard. No support. It might print better in smooth Filament.
Troubleshooting: If this sticks together, you can try scaling it up. That also increases the tolerances.
Categories:
163 Likes977 DownloadsNovember 2, 2024
163 Likes977 DownloadsNovember 2, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimNo