Grumpy Grim didn't want to get up this morning....Grumpy just wanted coffee....beware, she will get stabby if you mess with her coffee break.

The scythe and cup have been scaled to fit. You might need to use a little sandpaper to get them to fit, depending on what filament you use.

Painted 3mf included - verify settings, will work with your setup.

This is a model from last year. New Halloween is dropping weekly.

File is free for personal use only. If you want to sell it commercially, check out the merchant tier membership. I release anywhere from 10 to 20 designs per month.

Printing Recommendations: Initial Layer and Initial Layer Infill - 25 mm/s Layer Height: 0.20 mm - Prints shown are .16 mm Walls: 3 Infill: 10 - 15% Gyroid or Grid Supports: None needed — this design prints in place! Brim: Knobs only if you have adhesion issues. Cooling: Let the plate cool completely before removing your print to avoid warping or damage. Printer Acceleration: Slow down printer acceleration for smoother results. Printing the outer walls at half speed helps create a nice, clean finish.

**Looking for more designs? 🛍️ Browse the full collection in the Rebel Alicorn MMF Store **

⚠️ Important – Please Read: All Rebel Alicorn Designs are protected under Copyright Law. Your purchase grants you the right to download and print the design for personal use only. You do not have permission to: Resell, Remix, Alter, or Redistribute the digital files in any form No design modifications are allowed. Except for keyring holes and straw holes, other changes must be approved.

Selling physical prints of any Rebel Alicorn design requires authorization. To become an authorized seller, you must join the “Merchant Tier” on Patreon, Thangs, or MMF.

⚠️ Safety Warning: These designs are not suitable for unsupervised play by children or pets. Broken or rough-played 3D prints may produce sharp edges or small parts that can pose a choking hazard. Not recommended for children under age 5.