Needed a torch holder for my Bernzomatic TS4000. Made in Tinkercad. Just mount it on the wall. Must be upscaled for most torches.

Torch holder 

Needed a torch holder for my Bernzomatic TS4000. Made in Tinkercad.

Everyone at some point has been in the position of going through a door that locks from the other side. How do you get back in? always be ready with a Loc-Stop on your keychain! print in very strong filament!! (carbon fiber PC or carbon fiber nylon highly recommended!) this model was tested. Instructions: 1.Stick the triangle part of the model into the hole thing on the door where the latch goes in. 2. Make sure it extends out on the locking side. 3. Close the door.

Loc-Stop for doors

Everyone at some point has been in the position of going through a door that locks from the other side. How do you get back in? always be ready with a Loc-Stop on your keychain!

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

RavenDroneFlyer

Torch holder

Loc-Stop for doors