5 Drawer Solid Feet

I printed mine out of PETG but PLA will work fine.
But this I made these feet to replace the casters on my 5 Drawer Organizer I got from Amazon. I didn't want it rolling around my space and I didn't want it on the floor, and nobody else seems to have made feet for these yet. Or I can't find any. lol.
I believe these set the drawers at about the same height as if it had the casters and I'm almost positive I used the factory screws. Can't remember to be honest. But they work and that's all that matters.

ENJOY.....!!! :)

Hope someone can use this model. 
It is inspired by another model on T.V. but I can't remember the user or model. 
Either way this is a mount for a Samsung S20FE 5G.  It mounts your phone sideways on the dash.  And it has enough room in it to hold a phone that's inside a case.  The case I used is 3D printed but I'm sure others will fit as well.  And I put a hex pattern on it cuz i thought it looked kinda cool. haha...! 

This is printed in PETG but you can use whatever material you would like.  Just keep in mind that PLA has a low glass transition temp and could possibly deform in extreme heat. PETG isn't perfect but it's a little better. 

**NOTE: This will most likely fit other cars and phones, but I have not tested any. **

Either way I hope someone can use this. 
This is my first upload here so be sure to check out my other models. 

Phone Mount Toyota Camry S20FE Samsung

Just someone who makes a few models on the computer and feels that others may enjoy/use them.
So I hope you guys enjoy...!!!

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

NuahS912

Achievements

Seedling

5 Drawer Solid Feet

Phone Mount Toyota Camry S20FE Samsung