Over the past few months or so of having and using my first HOTO SNAPBLOQ I've realised a slight problem with it, which is that when you are using it you have three main parts of this tool; the screwdriver, bit case and then the screw driver case which clips onto the side of it the bit case.

I've realised that if your only using this at home for example on the workshop bench etc, and you need a home for it. I often find that the screwdriver case gets in the way so I made this case to make it easy to store as well as to make it so the screw driver holder can be left behind when your working on the bench.

The case I have made uses simple dove tail joints to join the three top halves and then they all slide onto the joined bottom halves with simple extrusions and a biscuit joint in the back, all the parts are within each file. There is no need to print all of them if you only have one like I do you could just print the first one and then use only one of them.

However I have only got my first one so far so I am not sure how the magnets will interact with each other when all three are in the case. Feel free to comment about it when you've made it.

I am looking forward to getting the other two to complete the set.

I think the SNAPBLOQ from HOTO is a great tool for makers and I would recommend it to anyone.

Hope this helps everyone! Enjoy! 😀